PVC semi-overall (KLARK) (221235)

Free model has a width of 140 cm in the waist, which will give comfort even to the rich men. Braces are made of high quality tactical fasteners made of nylon with length adjustment and a bridge that prevents the belt from slipping off the shoulders, the back lower part is made of reinforced elastic band for good cushioning during inclined squatting. To prevent the ends of the suspender belt from dangling, there is a locking frame. There are knee pockets and an internal pocket for small things. The top of the jumpsuit is lined with soft and strong ma, which is tightened with a cord and tightly pressed to the body. Such a soft cuff prevents getting inside the overalls. Additional options are possible to complete with a dense fleece insulated storage bag.

TOP FABRIC
Hermetically welded top made of European fabric, which is made according to the new technology of 2020 "UKOVEX HD". Due to the addition of
10% nitrile rubber to the fabric, rubber-like properties are obtained:

- elasticity and stretchability (stretch effect);
- antistaticity;
- frost resistance up to - 20 C;
- resistance to acids, alkalis, salt water, petrol, grease, mechanical;
- resistance to tears, tears, abrasions.

The fabric additionally has a special protective top coating against absorption of contaminants, which prevents damage to the fabric when exposed to toxic and chemical substances, sunlight, does not crumble and does not crack within 5-8 years.

The boots are hermetically welded with a flat seam, have a wide pad and a high rise. Boots do not squeeze and do not squeeze the foot, even if you wear boots with insulation, they are easy to remove and put on. The boots are produced on the technology of three-component sole has a layer of foam material, which gives the boots special consumer properties:

- insulating - make the sole of the boot warm;
- shock-absorbing - create the effect of a sneaker sole (feet do not get tired during prolonged wear);
- no unevenness of the surface (bumps, rubble, knots, roots, etc.) can be felt;
- the sole is less prone to puncture and cut;
- lighter weight of the boot with a thickened sole.

The seam of welding of the boot and fabric upper is as flat as possible, without pop-outs, which can rub the calves of the feet.

The combination of comfort, convenience and ease of care allows this model of footwear to be used for everyday wear and protection of feet from industrial pollution. There are models of industrial boots with maximum protection S5, which are made according to the standard DSTU EN-ISO 20345:

- have shockproof underfoot 200 J;
- anti-skid insole;
- anti-slip properties;
- chemical resistance.

Height without extension 38 cm. Boots meet the requirements of the standard DSTU EN-ISO 20347. The boots are made of high quality raw materials, have no odour, plaque on the surface of the boots, do not harden at subzero temperatures, which is confirmed by the sanitary-hygienic conclusion of the Ministry of Health of Ukraine.